Filter
Top Products
15
PROGRAMS FOR COPY MODE
Initial margin shift setting
This program is used to set the initial margin shift
amount.
The initial margin shift amount can be set from 0" to 1"
(0 mm to 20 mm) in increments of 1/8" (1 mm).
Normally the margin shift is set to 1/2" (10 mm) for both
the front and back of the paper.
Erase width adjustment
This program is used to set the initial width of edge
erase copying.
The edge erase width can be set from 0" to 1" (0 mm to
20 mm) in increments of 1/8" (1 mm).
The edge erase and center erase widths are normally
set to 1/2" (10 mm).
Card shot settings
This program is used to set the initial original size for
the card shot function.
Enter the X dimension (width) first and then the Y
dimension (length).
Both the X and Y dimensions can be set from 1" to
8-1/2" (25 mm to 210 mm) in increments of 1/8" (1 mm).
Setting a maximum number of copies
This program is used to set the maximum number of
copies that are allowed per original.
Any number from 1 to 999 can be set for the maximum.
The maximum number of copies is initially set to 999.
Disabling deletion of job programs
This program is used to prohibit the deletion and
changing of copy settings stored in job programs.
Disabling of bypass-tray in duplex copy
This program is used to disable the use of the bypass
tray when making duplex copies.
The bypass tray is often used to feed label sheets,
transparency film, and other special papers for which
two-sided copying is prohibited. If one of these special
papers enters the reversing unit, a misfeed or damage
to the unit may result. If special papers for which
two-sided copying is prohibited are often used, it is
recommended that you enable this program to prevent
feeding of special papers from the bypass tray into the
reversing unit during two-sided copying.
Disabling of auto paper selection
This program is used to disable the auto paper
selection function.
When this program is enabled, paper that is the same
size as the original placed on the document glass or in
the automatic document feeder is not automatically
selected.
Keyop_Sec.book 15 ページ ２００４年９月１５日 水曜日 午後８時３８分