Filter
Top Products
Setting the Date and Time
31
1. Installation
Setting the Date and Time
The date and time appear in the display, in reports, and at the top of
each page you transmit. Set the date and time by pressing the keys on
the operation panel as shown below.
Note: Make sure the display shows the date and time before
beginning a programming operation. If the display shows the
telephone line status, press the CHANGEOVER key to switch to the
date and time.
1
Press these keys:
The display will show:
2
Enter a two-digit number for the
month (“01” for January, “02” for
February, “12” for December, etc.).
• To correct a mistake, press the STOP
key to move the cursor back to the
mistake and then enter the correct
number.
FUNCTION
3
3
Enter a two-digit number for the day
(“01” to “31”).
4
Example: January
4:DATE&TIME SET MODE
DATE 06-08-2001
(Note: the currently set
date will appear to the
right of “DATE”)
0
1
Example: the 5th
0
5
4
Enter the year (four digits).
Example: 2001
1
00
2
all-FO4700.book Page 31 Tuesday, November 28, 2000 2:07 PM