Filter
Top Products
23
E
Menu Items
ADVANCED
AUTO (D-SUB[RGB]/DVI-I (analog))
The ANALOG GAIN and ANALOG OFFSET are automatically adjusted.
Pressing
ENTER
performs adjustment.
ANALOG GAIN (D-SUB[RGB]/DVI-I (analog))
Adjusts the bright portions of the video input signal.
ANALOG OFFSET (D-SUB[RGB]/DVI-I (analog))
Adjusts the dark portions of the video input signal.
3D-NR (AV input)
Reduce the noise of playback images on video.
Setting a higher level reduces more noise. However, it may cause blurring on an image.
MPEG-NR (AV input)
Reduce block noise caused by digital compression.
3D-Y/C (D-SUB[VIDEO])
Specify whether to perform 3-dimension Y/C separation.
If dot interference or cross-color is occurring in fast-motion scenes, selecting “OFF” may improve the image quality.
RGB INPUT RANGE (DVI-I/HDMI[PC]/HDMI[AV]/D-SUB[RGB]/DisplayPort)
Sets the RGB input signal range. When using HDMI or DisplayPort set to AUTO, the RGB input signal is detected
automatically. Use AUTO normally.
If the RGB input signal range cannot be set appropriately even when using AUTO, set according to the image. When the
setting is different, images will be displayed with washed out blacks and compressed gradients.
LOCAL DIMMING
Automatically controls the backlight brightness per area according to the image.
Increasing the level of this setting will result in higher contrast of the image, and will lower the monitor power consumption.
Light leakage and/or a ring-like appearance may be seen depending on the image. Change the setting in this situation.
(In PIP mode, the main side setting is reected in the image.)
POWER LIMITER
Can be set when LOCAL DIMMING is HIGH. Set the value so that it is smaller than the set power consumption (see page
57.) by adjusting the brightness, etc.
ACTIVE CONTRAST (AV input)
Automatically adjusts the contrast according to the image.
(In PIP mode, the main side setting is reected in the image.)
The adjustment operation may not be smooth depending on the image. In this case select OFF.
DISPLAY COLOR PATTERN
Displays a color pattern. Can be displayed while the menu screen is displayed, so you can refer to the pattern while adjusting
the image.
OFF ...............No pattern display.
WHITE ...........White single color pattern display.
RED...............Red single color pattern display.
GREEN .........Green single color pattern display.
BLUE .............Blue single color pattern display.
USER ............Red/green/blue mixed color pattern display. When USER is selected, set each color’s level.
RESET
Resets the values of the PICTURE menu items to the factory preset values.
Select “ON” and then press
ENTER
.