Filter
Top Products
Sharp AR-C200P: Setting up • 48
System Configuration Menu
The default settings are bold.
Item Value Description
POWER SAVE
DELAY TIME
5 min; 15 min; 30 min;
60 min; 240 min.
Sets the time before printer enters
power save mode.
PERSONALITY
Auto emulation;
PCL; IBM PPR III XL;
Epson FX; Adobe
PostScript
Selects the printer emulation
language. Note: the only printer
languages that can be selected are
those enabled in the Personality
section of the Maintenance
menu
.
USB
PS-PROTOCOL
ASCII
RAW
Specifies PostScript (PS)
communication protocol mode of
data from USB. (In RAW mode,
Ctrl-T is invalid.)
NETWORK
PS PROTOCOL
ASCII
RAW
This Item displays only when the
network card is installed.
Specifies PS communication
protocol mode of data from the
network card .
(In RAW mode, Ctrl-T is invalid.)
CLEARABLE
WARNING
On; Job PCL emulation: Sets the time before
deleting error messages. If changed
to Job, error remains displayed until
next print job is received.
PS emulation: Error messages are
only shown during job regardless of
setting.
AUTO
CONTINUE
On; Off Sets the printer to automatically
recover after a memory overflow or
print overrun.
MANUAL
TIMEOUT
60 sec; 30 sec; Off This parameter sets the period of
time, that after requesting paper to
be inserted and is not inserted,
when the print job is cancelled.
Only works in PostScript mode.
WAIT TIMEOUT
Off; 5 sec to 300 sec;
default = 40 sec
Sets the time between receiving the
last byte of data and the page being
automatically ejected.
Only works in PCL mode.
In PS mode the job will be
cancelled.