Filter
Top Products
Sharp AR-C200P: Setting up • 59
USB Menu
The default settings are bold.
Item Value Description
USB
ENABLE; DISABLE Selects USB interface.
SOFT RESET
ENABLE; DISABLE Enables/Disables soft reset
command.
OFFLINE
RECEIVE
ENABLE; DISABLE Enable = maintains reception without
changing the interface signal, even if
an alarm occurs. The interface stays
open even if the ON LINE button is
pressed. The interface issues a
BUSY signal only when the receive
buffer is full.
Network Menu
The default settings are bold.
Item Value Description
TCP/IP
ENABLE; DISABLE Selects TCP/IP protocol.
NETWARE
ENABLE; DISABLE Selects Netware protocol.
ETHERTALK
ENABLE; DISABLE Selects EtherTalk protocol.
NETBEUI
ENABLE; DISABLE Selects NetBEUI protocol.
FRAME TYPE
AUTO; 802.2; 802.3
ETHER-II; SNAP
Selects Ethernet frame type.
DHCP/BOOTP
ENABLE; DISABLE Selects whether selection of DHCP/
BOOTP is automatic.
RARP
ENABLE; DISABLE Selects whether selection of RARP is
automatic.
IP ADDRESS
xxx.xxx.xxx.xxx Configures IP address.
SUBNET MASK
xxx.xxx.xxx.xxx Configures subnet mask.
GATEWAY
ADDRESS
xxx.xxx.xxx.xxx Configures gateway address.
PRINT
SETTINGS
ON; OFF Selects printing of network menu
map.
ON = When printer exits the menu
mode it will print the network
MenuMap showing results of
self-diagnosis and settings.
INITIALIZE
ON; OFF Selects network initialization.
ON = network initializes as the
printer exits the menu.