Filter
Top Products
Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see Caller ID in
Chapter 7 for display messages related to Caller ID.
T.A.D. TRANSFER
The answering machine’s transfer function has been
turned on as explained in
Transfer Function
in
Chapter 2.
CHECK PAPER SIZE
The paper size setting is incorrect. Change the paper
size setting as described in
Loading the Paper
in
Chapter 1.
COVER OPEN
The print compartment cover (under the operation
panel) is open. Open the operation panel (grasp the
top and pull toward you), and then press down firmly
on both sides of the print compartment cover to close
it.
DOCUMENT JAM
The original document is jammed. See the following
section,
Clearing Paper Jams
.
FAX RX IN MEMORY
A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
FILM END
The imaging film may need replacement. Check the
film and replace if necessary.
FUNCTION MODE The FUNCTION key has been pressed.
HOLD
The HOLD/SEARCH key has been pressed to put
the other party on hold during a phone conversation.
Press the HOLD/SEARCH again to take the other
party off hold.
LINE ERROR
Transmission or reception was not successful. Press
STOP to clear the message, and then try again. If the
error persists, see
Line Error
in
Problems and
Solutions
in this chapter.
Display Messages
134