Sharp XR-1X Projector User Manual


 
17
Quick Start
5 After adjusting the focus, height and screen
size, press TENTER to finish the Setup
Guide.
4. Adjust the projected image with the Setup Guide
2
Focus (See page 27.)
Bring the projected
image into focus
using the focus ring.
4 Zoom (See page 28.)
Adjust the projected image size using the
zoom knob.
3 Angle (See page 28.)
Adjust the projector angle using the
HEIGHT ADJUST button.
Select the “INPUT 1” using the INPUT button on the projector or C INPUT 1 on the remote
control.
5. Select the INPUT mode
When pressing the INPUT button on the projector, input mode switches in order of
INPUT1 INPUT2 INPUT3
.
When using the remote control, press the CINPUT 1/DINPUT 2/EINPUT 3 button to
switch the INPUT mode.
6. Turn the Power off
Press the ON/STANDBY button, then press that button again while the confirmation message is
displayed, to put the projector into standby mode.
While the cooling fan is running, the Adjustment buttons blinks. (When
“Guide LEDs” is set to “On”. n page 48)
Unplug the power cord from the AC outlet after the cooling fan stops.
On-screen Display
On the
projector
On the remote
control
On the
projector
On the remote
control
zoom
in
On-screen display (RGB)
_P. 26
_P. 29
_P. 27
zoom
out
Focus ring
1 After the projector turns on, the Setup
Guide appears. (When “Setup Guide” is set
to “On”. n page 45)
Zoom knob
HEIGHT ADJUST
button
Refer to the Setup Guide screen to adjust
the focus, angle and zoom.
Press TENTER to finish the Setup Guide.