Filter
Top Products
Connections and Setup
-23
Controlling the
Projector Using an
RS-232C Cable
When the RS-232C terminal on the projector
is connected to a computer with an RS-232C
cable (null modem, cross type, commercially
available), the computer can be used to con-
trol the projector and check the status of the
projector. See page 65 for details.
1 Connect an RS-232C cable to
the projector.
2 Connect the above cable to the
computer.
Note
• Do not connect or disconnect an RS-232C
cable to or from the computer while it is
on. This may damage your computer.
• The RS-232C function may not operate if
your computer terminal is not correctly set
up. Refer to the operation manual of the
computer for details.
• Refer to “Computer Compatibility Chart”
on page 66 for a list of computer signals
compatible with the projector. Use with
computer signals other than those listed
may cause some of the functions not to
work.
Controlling the Projector by a Computer
Desktop computer
To RS-232C terminal
To RS-232C terminal
RS-232C cable
(commercially available)
XV_Z200U_E_p13_28.p65 03.10.21, 4:09 PM23