Filter
Top Products
Appendix
-63
Check
•Projector power cord is not plugged into the wall outlet.
•Selected input is wrong. (See page 31.)
•Cables incorrectly connected to back panel of the projector. (See pages
14–23.)
•“Contrast” and “Bright” adjustments are set to minimum position. (See
page 44.)
•Picture adjustments are not correct. (See page 44.)
•Adjust the focus. (See page 25.)
•Projection distance is too long or too short to allow for proper focus. (See
pages 26 and 27.)
•OSD Display is set to “OFF”, preventing to display some or all On-screen
Displays. (See page 51.)
•If the picture is normal, the sound is due to cabinet shrinkage caused by
temperature changes. This will not affect operation or performance of the
projector.
•Refer to “Maintenance Indicators” on page 58.
•Adjust the “Phase” setting. (See page 48.)
•Change the input signal type. (See page 52.)
If you encounter any problems during setup or operation of this projector, first refer to the
“Troubleshooting” section on this page. If this operation manual does not answer your ques-
tion, please call toll free 1-877-DTV-SHARP (1-877-388-7427) for further assistance. Or, send
us an e-mail at lcdsupport@sharpsec.com .
Our World Wide Web address is http://www.sharpusa.com/ .
Problem
No picture appears.
Color is faded or poor.
Picture is blurred.
No OSD appears.
An unusual sound is
occasionally heard from the
cabinet.
Maintenance indicator
illuminates.
Picture noise appears.
Image is green on INPUT 2
Component.
Image is pink (no green) on
INPUT 2 RGB.
Kensington Security
Standard connector
This projector has a Kensington Secu-
rity Standard connector for use with a
Kensington MicroSaver Security Sys-
tem. Refer to the information that came
with the system for instructions on how
to use it to secure the projector.
Rear View
Using the Kensington Lock
Troubleshooting
For SHARP Assistance (U.S.A. only)
XV_Z200U_E_p57_66.p65 03.10.21, 4:21 PM63