Filter
Top Products
Page 10
Windows 98/95
To check your port settings in Windows 98/95/3.1, do the following:
1. Press start button, go to setting then control panel.
2. Double click on system icon.
3. Click on device manager tab.
4. Click on ports.
5. Double click on port you wish to use for FlashLink and write down
port number.
6. Click on resources tab.
7. Write down first number of the first input/output range line. Should be
something like 3BC. This is your base address.
Then start your FlashLink Software and select from the top menu “Customize”.
Then click the “Set Port” button. You will see the port-setting value that
FlashLink Software is using in the “Base Address” field. Put the port-setting
value that you wrote down from the above instructions into the “Base Address”
field.
Windows 3.1
Uses Standard port configuration.