SkyLink HU-318 Switch User Manual


  Open as PDF
of 34
 
27
RESETTING THE INTERNET HUB
APPENDIX
RESETTIING THE INTERNET HUB APPENDIX
The installation of the Internet Hub is divided into two parts - Internal Access and
Remote Access. Internal Access allows you to control the Internet Hub within the
home network. Remote Access allows you to have control of the Internet
Hub even when you are away from home. Always start with the Internal Access
Installationrst.AftersettinguptheInternetHubinternally,youmayproceedto
Remote Access installation.
Refer to the Section3[PROGRAMMINGTHEINTERNETHUB] of this User’s
Manual for the Installation.
Resetting the Internet Hub
PleasenotetheIPaddressshouldfallintothesamesubnet(192.168.1.XXX)of
yourexistingnetworkorCable/DSLrouter.Ifthisisnotthecase,youcanresetthe
InternetHubtofactorydefaultandtryagainorcheckwhethertheDHCPServeris
enabledinyourCable/DSLrouter.PleaserefertoyourCable/DSLrouterUser’s
Instructions for details.
1. Unplug the network cable before resetting the Internet Hub.
2.PressandholdtheresetbuttonlocatedatthebackoftheInternetHub
for5secondsuntiltheRFandPowerLEDindicatoronthefrontare
steadilyon.TheLCDshouldnowshow“Resetting...”
3.ShortlyafterawhiletheLCDshouldshowthe“Skylink”logowith
afactorydefaultIPaddress.
4.Pluginthenetworkcableandgotothe‘ProgrammingtheInternetHub’
instructions found under Section 3 of this User’s Manual
RESET
 previous next