Filter
Top Products
4
Setting the Date and Time
FotoChute has an internal time of day clock that it uses for applying
time stamps to various folder names. Before you begin to copy files
using FotoChute, use the following steps to set the date and time.
1. Locate the Power Switch on the side of your FotoChute and
slide it to the ON position.
2. From the Main Menu, press the Down button three times to
highlight Information, and then press Select.
3. Press the Down button twice to highlight Set Time, and then
press Select.
4. Use the Up and Down buttons to change the date or time
value, and use the Left and Right buttons to move to the next
date or time field.
5. After you finish setting both date and time, press the
OK/Copy button. When prompted to confirm, press the
OK/Copy button to save the new settings, or Left to cancel.
Which Interface: USB Host or Device?
USB OTG provides for two ways to connect to other USB ports.
When you want to connect to a PC or Mac to transfer files between
FotoChute and the computer, you must connect to that computer
through FotoChute’s USB Device port, which uses the attached USB
A-Plug.
When you want to copy data from a supported camera, flash disk or
memory card reader, you must connect to that device through
FotoChute’s USB Host port, which uses the USB A-Jack.