Filter
Top Products
51
51
None
No IRQ selected
3
IRQ 3 selected
4
IRQ 4 selected
5
IRQ 5 selected
7 (*)
IRQ 7 selected
(*) = Default setting
• Note: not all consecutive IRQ numbers from 3 to 15 can be used; to help the selection, the
Setup program displays legal IRQ numbers only.
Parallel DMA Channel
Option Description Note
None (*)
No DMA selected for the Parallel Port
(*) = Default setting
0
DMA Channel 0 selected
1
DMA Channel 1 selected
3
DMA Channel 3 selected
Parallel Port Mode
The user according the parallel device connected to the interface can choose The Parallel Port
Mode
. The default mode is Bidirectional.
Option Description Note
Printer (*)
Standard mono-directional printer interface
(*) = Default setting
Bidirectional
Bidirectional printer interface
EPP-1.9 and SPP
EPP and SPP mode
EPP-1.7 and SPP
EPP and SPP mode
ECP
ECP mode
ECP and EPP-1.9
ECP and EPP mode
ECP and EPP-1.7
ECP and EPP mode
ATAPI Units Page
This option concerns about mass storage devices using a standard
EIDE interface.
The CPU board has two EIDE controllers, so the
ATAPI Units can be separated in two parts:
ATAPI Primary and ATAPI Secondary. In any case the options are the same.
• Note: ATAPI (or EIDE) devices can be both hard disks and CD_ROM devices or, sometimes,
storage
tape-units.
• Note: each EIDE interface supports two peripherals, called master unit and slave unit.
Remember to select as
master unit a bootable disk (containing any valid O.S.).