Filter
Top Products
Installing the Card
1. Power off your PC and remove its cover.
2. If you have purchased an optional boot ROM, plug the
boot ROM into the socket on the card, making sure the
notch on the memory device and that on the socket are in
the same direction.
3. Select an available expansion slot and plug in the card.
4. Connect your card using the appropriate network connection
(RJ-45, BNC or AUI).
5. Power on the PC.
6. Follow the appropriate instructions in this chapter to
configure the card and load the network drivers.
Configuring the Card
Important: It is recommended that you read the RELEASE.TXT
file located on the driver diskette. This file provides information
about the disk’s contents. The contents of the file is displayed
by typing the following command at the DOS prompt:
TYPE RELEASE.TXT Press <Enter>
To install and run the configuration program, proceed as
follows:
1. Insert the driver diskette in drive A: or B:
2. Type the following command at the DOS prompt:
INSTALL <PATH> Press <Enter>
where: <PATH> is the directory location where you wish to
install the program.
v
QUICK START
ISA-FINAL 3/31/98 4:06 PM Page vii