Filter
Top Products
IP I
NTERFACE
C
OMMANDS
35-2
ip address
This command sets the IP address for the currently selected VLAN
interface. Use the no form to remove the current IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
Default Setting
DHCP
Command Mode
Interface Configuration (VLAN)
Command Usage
• You must assign an IP address to this device to gain management
access over the network or to connect the switch to existing IP
subnets. You can manually configure a specific IP address, or direct
the device to obtain an address from a BOOTP or DHCP server. Valid
IP addresses consist of four numbers, 0 to 255, separated by periods.
Anything outside this format will not be accepted by the configuration
program.
• If you select the bootp or dhcp option, IP is enabled but will not
function until a BOOTP or DHCP reply has been received. Requests
will be broadcast periodically by this device in an effort to learn its IP
address. (BOOTP and DHCP values can include the IP address,
default gateway, and subnet mask).
• You can start broadcasting BOOTP or DHCP requests by entering an
ip dhcp restart command, or by rebooting the switch.