Filter
Top Products
U
SING
THE
C
OMMAND
L
INE
I
NTERFACE
4-3
After you configure the switch with an IP address, you can open a Telnet
session by performing these steps:
1. From the remote host, enter the Telnet command and the IP address of
the device you want to access.
2. At the prompt, enter the user name and system password. The CLI will
display the “Vty-0#” prompt for the administrator to show that you are
using privileged access mode (i.e., Privileged Exec), or “Vty-0>” for the
guest to show that you are using normal access mode (i.e., Normal
Exec).
3. Enter the necessary commands to complete your desired tasks.
4. When finished, exit the session with the “quit” or “exit” command.
After entering the Telnet command, the login screen displays:
Note: You can open up to four sessions to the device via Telnet.
Username: admin
Password:
CLI session with the SMC8612T2 is opened.
To end the CLI session, enter [Exit].
Vty-0#