Filter
Top Products
C
ONFIGURING
THE
S
WITCH
3-26
CLI – Enter the IP address of the TFTP server, specify the source file on
the server, set the startup file name on the switch, and then restart the
switch
.
If you download the startup configuration file under a new file name, you
can set this file as the startup file at a later time, and then restart the switch.
Resetting the System
Web – Click System, Reset. Click the Reset button to restart the switch.
Figure 3-12 Resetting the System
CLI – Use the reload command to restart the switch.
Note: When restarting the system, it will always run the Power-On
Self-Test.
Console#copy tftp startup-config 4-86
TFTP server ip address: 192.168.1.19
Source configuration file name: config-1
Startup configuration file name [] : startup
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#reload
Console#config
Console(config)#boot system config: startup-new 4-92
Console(config)#exit
Console#reload 4-29
Console#reload 4-29
System will be restarted, continue <y/n>? y