Filter
Top Products
B
ASIC
C
ONFIGURATION
3-17
Web – Click System, Bridge Extension Configuration.
Figure 3-5 Bridge Extension Configuration
CLI – Enter the following command.
Setting the Switch’s IP Address
This section describes how to configure an IP interface for management
access over the network. The IP address for this switch is unassigned by
default. To manually configure an address, you need to change the switch’s
default settings (IP address 0.0.0.0 and netmask 255.0.0.0) to values that
are compatible with your network. You may also need to a establish a
default gateway between the switch and management stations that exist on
another network segment.
Console#show bridge-ext 4-250
Max support vlan numbers: 255
Max support vlan ID: 4094
Extended multicast filtering services: No
Static entry individual port: Yes
VLAN learning: IVL
Configurable PVID tagging: Yes
Local VLAN capable: No
Traffic classes: Enabled
Global GVRP status: Disabled
GMRP: Disabled
Console#