Filter
Top Products
VLAN C
OMMANDS
4-243
To configure protocol-based VLANs, follow these steps:
1. First configure VLAN groups for the protocols you want to use
(page -233). Although not mandatory, we suggest configuring a
separate VLAN for each major protocol running on your network.
Do not add port members at this time.
2. Create a protocol group for each of the protocols you want to
assign to a VLAN using the protocol-vlan protocol-group
command (General Configuration mode).
3. Then map the protocol for each interface to the appropriate
VLAN using the protocol-vlan protocol-group command
(Interface Configuration mode).
protocol-vlan protocol-group (Configuring Groups)
This command creates a protocol group, adds specific protocols to a
group. Use the no form to remove a protocol group.
Syntax
protocol-vlan protocol-group group-id [{add | remove}
frame_type frame protocol-type protocol]
no protocol-vlan protocol-group group-id
• group-id - Group identifier of this protocol group. (Range:
1-2147483647)
• frame - Frame type used by this protocol. (Options: ethernet,
rfc_1042, llc_other)
• protocol - Protocol type. The only option for the llc_other frame
type is ipx_raw. The options for all other frames types include: ip,
arp, rarp.
Default Setting
No protocol groups are configured.
Command Mode
Global Configuration