Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-118
access-list ip
This command adds an IP access list and enters configuration mode for
standard or extended IP ACLs. Use the no form to remove the specified
ACL.
Syntax
[no] access-list ip {standard | extended} acl_name
• standard – Specifies an ACL that filters packets based on the
source IP address.
• extended – Specifies an ACL that filters packets based on the
source or destination IP address, and other more specific criteria.
• acl_name – Name of the ACL. (Maximum length: 16 characters)
access-list ip
mask-precedence
Accesses the IP Mask mode used to
configure access control mask
GC 4-124
mask Sets a precedence mask for the ACL
rules
IP-Mask 4-125
show access-list ip
mask-precedence
Shows the ingress or egress rule masks
for IP ACLs
PE 4-128
ip access-group Adds a port to an IP ACL IC 4-129
show ip
access-group
Shows port assignments for IP ACLs PE 4-129
map access-list ip Sets the CoS value and corresponding
output queue for packets matching an
ACL rule
IC 4-130
show map
access-list ip
Shows CoS value mapped to an access
list for an interface
PE 4-132
match access-list ip Changes the 802.1p priority, IP
Precedence, or DSCP Priority of a
frame matching the defined rule (i.e.,
also called packet marking)
IC 4-133
show marking Displays the current configuration for
packet marking
PE 4-134
Table 4-33 IP ACL Commands (Continued)
Command Function Mode Page