Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-154
snmp-server enable traps
This command enables this device to send Simple Network Management
Protocol traps (SNMP notifications). Use the no form to disable SNMP
notifications.
Syntax
[no] snmp-server enable traps [authentication | link-up-down]
• authentication - Keyword to issue authentication failure traps.
• link-up-down - Keyword to issue link-up or link-down traps.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server enable traps command, no
notifications controlled by this command are sent. In order to
configure this device to send SNMP notifications, you must enter at
least one snmp-server enable traps command. If you enter the
command with no keywords, both authentication and link-up-down
notifications are enabled. If you enter the command with a keyword,
only the notification type related to that keyword is enabled.
•The snmp-server enable traps command is used in conjunction with
the snmp-server host command. Use the snmp-server host
command to specify which host or hosts receive SNMP notifications.
In order to send notifications, you must configure at least one
snmp-server host command.
Example
Console(config)#snmp-server enable traps link-up-down
Console(config)#