Filter
Top Products
SonicWALL CSM Series Appliance Getting Started Guide Page 31
Adding a Static Route to the SonicWALL ADConnector
If the SonicWALL ADConnector is installed on a computer in a different subnet than the
SonicWALL
CSM, you need to add a static route in the SonicWALL CSM to the
SonicWALL ADConnector station:
1. In the SonicWALL CSM management interface, in the left-navigation menu, click
Network and then click Interfaces.
2. In the Network > Interfaces page, click Add below the Route table.
3. Click Add in the Routing Table section. The Add Route window is displayed.
4. Enter the beginning IP address of the IP address range to which the SonicWALL
ADConnector belongs in the IP Address From field.
5. Enter the ending IP address of the IP address in the IP Address To field.
6. Enter the IP address of the gateway device to which the SonicWALL ADConnector is
attached in the Gateway IP field.
7. Select Internal (X0) from the Interface menu.
8. Click OK. The static route entry is added to the Routing Table.
Note: For instructions on assigning filter policies to users in Active Directory, refer to
the SonicOS CF 2.5 Administrator’s Guide.