Filter
Top Products
15
Projecting an Image
Projecting/Adjusting an Image
When the projected image a trapezoid, tapering to the right or left
1 Press KEYSTONE on the remote
commander twice or select H Keystone in
the INSTALL SETTING menu.
2 Use V/v/B/b to set the value. The higher
the setting, the narrower the right part of
the projected image. The lower the setting,
the narrower the left part.
• Since the Keystone adjustment is an electronic correction, the image may be deteriorated.
• Depending on the position adjusted with the lens shift feature, the aspect ratio of the image may
change from the original or projected image may be distorted with Keystone adjustment.
Correcting the image twist (Warp correction feature)
You can correct the image twist by the warp correction feature
1 Press KEYSTONE on the remote
commander three times, or select
“Warping” in the INSTALL SETTING
menu, and select “Adjust.”
2 The guide is displayed.
The corners of the image to be corrected
1 Move the s by using V/v/B/b to select
the corner you want to correct.
If you press ENTER, you will go back to
the cursor display.
2 Adjust the position of the corner you want
to correct by using V/v/B/b.
Notes
Increase the number
towards minus
Increase the number
towards plus
Adjust using this cursor.