Filter
Top Products
62
Enjoying AIBO’s performance
In the performance mode, AIBO shows you various performances. You can
ask for a particular performance by sending commands to AIBO.
Furthermore, you can create a new performance by using the ERF-510 AIBO
Performer Kit.
Setting AIBO to the performance mode
When AIBO is sleeping, shake it awake. When it is placed on the station, take
it from the station and shake it awake (see page 39). Then, set it to the
performance mode. AIBO starts performing.
1 Make sure the switch is set to A or B.
With this setting, you can use the controller with the numeric
commands.
2 Make sure the sound controller is turned on.
When the power is on, all the controller lamps light up.
To turn the power on, press the
C
button.
3 Press the buttons in order as shown below to set AIBO to the performance mode.
The eye lamps flash, and AIBO starts performing.
If AIBO does not respond to commands
When set for the numeric commands, press “8”t“0”t“SEND” to match AIBO’s
command type (A, B) to that of the sound controller.
To send commands with single sound commands or with musical instruments
See “Command list” on page 91, and send the musical tones corresponding to each
command.
SEND
02