Filter
Top Products
13
3 In My Computer, click the CD-ROM drive icon and then double-click
setup.exe.
The installation program starts. Follow the on-screen instructions
and install the utility software.
● Depending on your computer’s settings, the file name Setup.exe may be
displayed as Setup.
Procedure 5 - Configuring the Access Point settings
Display the Access Point Setup Page and set up the Access Point.
The following browsers are compatible:
● Internet Explorer 5.5 or later;
● Netscape 6.1 or later.
● To display the Wireless LAN Access Point Setup Page from the PCWA-A320 Access Point
software, set one of the Web browsers above as your computer’s default Web browser.
If your Web browser is configured to use a proxy server, set the browser proxy settings
so the browser does not use a proxy server for the IP address of the Access Point. For
details on how to disable the proxy settings, consult your Troubleshooting Guide - Case 3.
● The Wireless LAN Access Point Setup Page is saved in the internal memory of the
Access Point.
Proceed as follows to configure the Access Point settings:
1 Click the Start button, point to Programs (All Programs in
Windows XP), Wireless LAN and click Access Point Scan.
The Scan Utility starts up, and automatically searches for Access Points
on the same network. Once the Scan Utility finishes searching for
Access Points, it displays a list of Access Points.
If the Scan Utility does not find any Access Points, move the computer to
a location that provides good conditions for wireless communication with
the Access Point and click Scan to search again. For details, refer to the
Troubleshooting Guide - Case 1.
2 Select the Access Point to which you want to connect from the list of
Access Points that were found by the Scan Utility.
If multiple Access Points are shown in the list, check the MAC addresses.
Each Access Point’s MAC address is printed on a bar code label inside the
rear cover of the Wireless Unit. After checking the MAC address, make
sure to reconnect the Ethernet cable.