Filter
Top Products
15
Procedure 6 - Configuring computer settings
Configure the Network Name (SSID) and Encryption (WEP) wireless
communication settings on the computer to match those set on the
Access Point in Procedure 5. After making the settings of your computer,
communication with the Access Point will be enabled.
Refer to the instructions of your Wireless LAN PC Card or Wireless
LAN Converter.
Installing the Access Point
Procedure 7 - Installing the Access Point
When configuration is finished, install the Access Point. Its settings are stored
so that even when it is turned off, the settings are preserved. The Wireless
Unit can be hung to walls.
The settings are now complete.
Resetting the Access Point to factory defaults
1 Turn on the Access Point.
2 With a paper clip or similar object, press and hold the Reset switch
at the bottom of the Wireless Unit for at least one second.
When you press the Reset switch, the indicator on the front of the
Wireless Unit lights red and it starts flashing when the switch is pressed
for one second.
3 When the status indicator starts flashing red, release the Reset switch.
The Access Point restarts under the default settings.
Quick Setup swich
Reset switch