Filter
Top Products
8
To reset to the Access Point factory default settings, proceed as follows:
1 Turn on the unit.
2 Press and hold the Reset switch on the bottom of the Wireless Unit for
at least a second with a paper clip.
Be careful not to press the Quick Setup switch by mistake when you reset
the Wireless Unit.
3 When the status indicator flashes, release the Reset switch.
The Wireless Unit restarts automatically with all settings returned
to its factory defaults.
Capabilities
Wireless access to the Internet from a variety of locations
The Wireless LAN Access Point PCWA-A320 (hereafter referred to as Access
Point) is an IEEE 802.11g compliant bridge-type 2.4 GHz wireless LAN access
point. You can use the Access Point as a base station to build a wireless LAN
system consisting of computers equipped with Wireless LAN PC Cards or
Wireless LAN Converters.
If you want to enable the computers that are connected to the wireless LAN
to access the Internet, simply connect the Access Point to a DSL modem, cable
modem, ISDN router, broadband router or another similar communication
device, or to an Ethernet LAN (wired LAN) that is connected to the Internet.
● Use an Ethernet cable to connect the Access Point to the communication device. You
cannot use a USB connection to connect the Access Point to a communication device.
Connect the Access Point to a communication device with a router function. If the
communication device does not have a router function (such as a cable modem),
a separate broadband router is required.