Filter
Top Products
35
GB
The INSTALL SETTING Menu
Adjustments and Settings Using the Menu
The INSTALL
SETTING Menu
The INSTALL SETTING menu is used for
changing the settings of the projector.
Tilt...
Adjusts the position (height) of the projected
picture. Pressing the f on the TILT
adjustment key or M/, key on the Remote
Commander, the more the projector tilts and
the higher the position of the picture.
Pressing the F on the TILT adjustment key
or m/< key on the Remote Commander,
the less the projector tilts and the lower the
position of the picture.
V Keystone
Corrects the trapezoidal distortion caused by
the projection angle. Select “Auto” for
automatic correction, or “Manual” for
manual correction using the < or , key.
When the bottom of the trapezoid is
longer than the top : Sets a lower
value.
When the top of the trapezoid is longer
than the bottom : Sets a higher
value.
The auto V Keystone adjustment may not
correct the trapezoidal distortion perfectly,
depending on the room temperature or the
screen angle.
Side Shot
Corrects the horizontal trapezoidal
distortion of the picture using the < or ,
key on the Remote Commander.
When the right side is longer than the
left side ( )
Set to a higher value (+ direction).
When the left side is longer than the
right side ( )
Set to a lower value (– direction).
Set the adjustment level to “0” if you want to
adjust the picture more widely using “V
Keystone” only.
Even when projecting using “Side Shot”, the
four sides of a picture may sometimes not be
parallel to the respective sides of a screen
frame.
Image Flip
Flips the image on the screen horizontally
and/or vertically.
Off: The image does not flip.
HV: Flips the image horizontally and
vertically.
H: Flips the image horizontally.
V: Flips the image vertically.
Background
Select the background color of the screen
when no signal is input to the projector.
Select “Black” or “Blue”.
Normally, set to “Blue.”
Test Pattern
The factory setting is “Off.”
When set to “On,” a test pattern is displayed
on the screen during the “Lens Zoom”
adjustment, “Lens Focus,” “Side Shot” or
“V Keystone.” If you do not want to display
a test pattern, set to “Off”.
Lamp Mode
Sets the lamp brightness in the projection.
Menu Items
Note
INSTALL SETTING
Input-A
Tilt...
V Keystone: Auto
Side Shot: 0
Image Flip: Off
Background: Blue
Test Pattern: Off
Lamp Mode: Standard
Lens Control: On
Direct Power On: Off
High Altitude Mode
: Off
Security Lock: Off
Note