Sony VPL-PS10 Projector User Manual


 
12 (GB)
7 INPUT key
Selects the input signal. Each time you press the key,
the input signal switches as follows:
Notes
• You can select INPUT-B only if INPUT-B FUNC. in
the INSTALL SETTING menu has been set to ON.
INPUT-B is only available for the VPL-PX15.
• The audio signals are the same for the VIDEO and
S-VIDEO.
• The audio signals are the same for the INPUT-A and
INPUT-B.
8 I / 1 (on / standby) key
Turns the projector on and off when the projector is in
the standby mode. The ON/STANDBY indicator
lights in green when the power is turned on.
When turning off the power, press the I / 1 key
twice following the message on the screen, or press
and hold the key for about one second.
For details on steps for turning off the power, see “To turn
off the power” on page 25 (GB).
9 MENU key
Displays the on-screen menu. Press again to clear the
menu.
0 Indicators
LAMP/COVER: Lights up or flashes under the
following conditions:
Lights up when the lamp has reached the end of
its life or has reached a high temperature.
Flashes when the lamp cover or air filter cover
is not secured firmly.
TEMP (Temperature)/FAN: Lights up or flashes
under the following conditions:
Lights up when temperature inside the projector
becomes unusually high.
Flashes when the fan is broken.
Location and Function of Controls
INPUT-A
S-VIDEO VIDEO
INPUT-B (VPL-PX15 only)
POWER SAVING: Lights up when the projector is
in the power saving mode. When POWER
SAVING in the SET SETTING menu is set to
ON, the projector goes into the power saving
mode if no signal is input for 10 minutes.
Although the lamp goes out, the cooling fan
keeps running. The power saving mode is
canceled when a signal is input or any key is
pressed. However, in the power saving mode,
none of the keys function for the first 60 seconds.
ON/STANDBY: Lights up or flashes under the
following conditions:
Lights up in red when the AC power cord is
plugged into the wall outlet. Once in the
standby mode, you can turn on the projector
with the
I / 1
key.
Lights up in green when the power is turned on.
Flashes in green while the cooling fan runs after
the power is turned off with the
I / 1
key. The
fan runs for about 90 seconds after turning off
the power.
The ON/STANDBY indicator flashes quickly
for the first 60 seconds of that time.
During this first 60 seconds, you cannot turn the
power back on with the
I / 1
key.
For details on the LAMP/COVER and the TEMP/FAN
indicators, see page 40 (GB).