Filter
Top Products
SY-K7VTA PRO V1.0
Quick Start Guide
21
Audio issue
How can I disable the on-board Audio?
Go to the SOYO Combo Feature in the BIOS setup, then set the "Onchip sound" or "AC97 Audio" to
disable. Please also make sure ‘Legacy Audio’ is disable if there is one.
I cannot get the sound working on my system.
1. check if the speaker wire is connected to the line out connector in the M/B
2. check if the speaker power is powered on
3. install the audio driver supplied on our driver disc.
4. if sound already installed, check our website for audio driver update.
The sound is working in my system, but when I play CD music from the CD-ROM, I do not get
any sound. What is wrong?
This is because the 3-wire audio cable from the CD-ROM to the on-board CDIN1 connector in the M/B.
The sound from my sound card is distorted when Windows start. What is wrong?
1. if you are using an ISA sound card, please make sure the IRQ needed for the sound card is set
to 'Legacy ISA' in the bios. In other word, if your ISA sound card takes IRQ5, then set IRQ5
to 'Legacy ISA'.
2.
install the VIA 4 in 1 driver for the motherboard
The sound and everything else works fine except that the recorder and microphone do not work.
What is wrong?
Please go to sound properties and check if the recorder and microphone in the are enabled
check if Microphone is ok
Hard disk issue
My Western digital HDD is not detected during boot-up or No fix disk present.
Change the jumper settings to cable select or single or remove the jumpers.
For updated FAQs, please check
http://www.soyo.com.tw/faq.htm or
http://www.soyousa.com/faqs.html