Filter
Top Products
Hardware Setup SY-5SSM & SY-5SSM/5
25
cause the system to restart the boot-up sequence.
3. Speaker
Attach the 4-pin PC speaker cable from the case to the Speaker
connector on the Motherboard.
4. ACPI/APM LED
Connecting the 2-pin ACPI LED cable to the corresponding
ACPI/APM connector on the motherboard.
In full power on state, this LED will be always turned on.
In low power (suspend) state, this LED will be blinking.
5. IDE LED
Attach the 2-pin IDE device LED cable to the corresponding IDE
LED connector on the Motherboard. This will cause the LED to
lighten when an IDE (HDD, CD-ROM) device is active.
6. ATX Power On/Off Switch
Attach the 2-pin momentary type switch to the PWRBT connector for
turning On or Off your ATX power supply.