Filter
Top Products
SY-KT600 DRAGON Plus Quick Start Guide
18
Hardware
Installation
CMOS Clear (JP5)
In some cases the CMOS memory may contain wrong data, follow the steps below to
clear the CMOS memory.
1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. Its
white cap can easily identify this jumper.
2. Put the jumper back to 1-2 to allow writing of new data into the CMOS memory.
CMOS Clearing Clear CMOS Data Retain CMOS Data
JP5 Setting
Short pin 2-3 for
at least 5 seconds to
clear the CMOS
Short pin 1-2 to
retain new settings
Note: You must unplug the ATX power cable from the ATX power connector
when performing the CMOS Clear operation.
On-board Speaker connection
When using 2-channel speaker, connect the speaker cable to Line-out.
If you’re using 4 channel speaker, connect the front L/R speakers to Line-out and rear L/R speakers
to Line-in. Make sure that the audio software is set for 4 channel speaker system.
If you are using 6 channel speaker, connect the front L/R speakers to Line-out and the rear L/R
speakers to Line-in. Connect the Center/Bass to Mic-in.
Line-in
Line-ou
t
Mic
-
in
321
321