Support User Manuals

Spectra Logic T200 Computer Drive User Manual

Open as PDF

of 22

Installing the Cover or Securing the Rear Door

May 2010 Spectra T200, T380, T680, T950, or T-Finity Library

21

Testing the Drive

1. Poweronandrestartthehostcomputer,ifyoupowereditoff.

2. Determinewhetheryourbackupsoftwareanddriveare

communicatingproperly.

a. Usethesoftwaretowriteseveralmegabytesofdatausingthenewly

installeddrive.

b. Performacomparisoncheckonthebackupdatatoconfirmthatit

waswrittencorrectly.

Installing the Cover or Securing the Rear Door

Spectra T200 or T380 Replacetheprotectivecoverafteryoucompletethe

installation.

1. Liftthecoverandalignitsothatthetwonutsextendingfromtheback

ofthecoverfitintothecorrespondingholesoneithersideofthechassis

(Figure 5).IfthecablestothedrivesandQIPsinstalledinthelibraryare

routedfromthe:

 topofthelibrary,makesurethattheyfitintothecutoutinthetopof

thecover.

 bottomofthelibrary,makesurethattheyfitintothecutoutinthe

bottomofthecover.

2. Usingyourfingersora#2Phillipsscrewdriver,tightenthetwoscrews

tosecurethebottomofthecovertothechassis(seeFigure 4on

page 11).

Spectra T680 Closeandlocktheprotectivedooronthebackofthelibrary

rack(seeFigure 6onpage 11).

Spectra T950 or T-Finity Closeandlocktheprotectivedoorsonthebackof

thelibrary(seeFigure 7onpage 12).

Adding the Drive to a Partition

 Replacementdrive—Ifyoureplacedadrive,thenewdriveis

automaticallyaddedtothepartitionoftheolddrive.

 Newdrive—Ifyouinstalledanadditional(new)drive,youneedtoadd

ittoapartitionbeforeyoucanbeginusingitforbackupoperations.

RefertotheindividualUser

Guideforinstructions.

Caution

Make sure that cables are not pinched between the cover and the chassis.

previous