Spectra Logic T950 Computer Drive User Manual


 
Installing the Drive
May 2010 Spectra T200, T380, T680, T950, or T-Finity Library
15
2. Removethedrivefromitsprotectivepackaging.
3. Whilesupportingthebottomofthedrivesled,slidethenewdriveinto
theemptydrivebay(Figure 11).Pushthedriveinuntilanaudibleclick
indicatesthatithaslockedintoplace.
Important
If you are installing a replacement drive, install the new drive in the same location
as the old drive.
Important
Follow this precaution if your FC tape drive has the connectors on the side, as
shown Figure 10.
While sliding a Fibre Channel tape drive located in the left-most location into the
library, ensure that you hold the Fibre Channel cable of the adjacent Fibre Channel
tape drive out of the way to prevent damaging the cable.
Figure 10 Installing a Fibre Channel drive.
Hold the cable of
the adjacent Fibre
Channel tape drive
out of the way
while removing
or installing a FC
tape drive.
Note: the Fibre
channel connector
on your tape drive
may not look the
same as the one
shown here.
Caution
The drive sled weighs approximately 15 lb. (7 kg). Be careful not to drop it.
Be careful not to damage or dislodge any cables connected to adjacent drives.