Filter
Top Products
Regulatory Information
Section 3B. Regulatory Information 25
larger display screens). To comply with FCC RF
exposure requirements, this modem should not be
used in configurations that cannot maintain at least
11 mm (approximately 0.43” or 7/16”) from users
and bystanders; for example, in certain notebook
and tablet computers and configurations where the
USB connectors are unable to provide or ensure
the necessary separation is available between the
modem and its users to satisfy compliance.
RF Exposure/Specific Absorption Rate
(SAR) Information
This product has been evaluated for SAR and
meets the FCC Guidelines for exposure to radio
waves.
FCC Equipment Authorization ID: PKRNVWMC760
Your wireless modem is a radio transmitter and
receiver. It is designed and manufactured not to
exceed the exposure limits for radio frequency (RF)
energy set by the Federal Communications
Commission (FCC) of the U.S. Government. These
limits are part of comprehensive guidelines and
establish permitted levels of RF energy for the
general population. The guidelines are based on
standards that were developed by independent
scientific organizations through periodic and
thorough evaluation of scientific studies. The
standards include a substantial safety margin
designed to assure the safety of all persons,
regardless of age and health.
The exposure standard for wireless devices
including mobile USB Modems and wireless
modems uses a unit of measurement known as the
Specific Absorption Rate, or SAR. Tests for SAR are
conducted using standard operating positions
reviewed by the FCC with the device under test
transmitting at its highest certified power level in all
frequency bands. Although the SAR is determined
at the highest certified power level, the actual SAR
level of the USB Modem or modem while operating
can be well below the maximum value. This is
because the USB Modem is designed to operate at
multiple power levels so as to use only the power
required to reach the network. In general, the closer
you are to a wireless base station antenna, the
lower the power output.