A SERVICE OF

logo

128
APPENDIX
Available DIP switch settings (Parallel Interface)
The following table shows all the possible settings for the DIP switch. The
factory default settings are ON for switches 1 through 7 and OFF for switch 8.
A reset can be performed with pin 31 on the interface by setting DIP switch 1 to
ON (the factory default setting).
In addition, when a reset can be performed with pin 31, setting DIP switch 2 to
OFF sets up the unit to perform a reset when pin 31 and pin 36 are “LOW”.
*1: Never set switch 7 to OFF at the same time that switch 8 is set to ON.
Switch Parameter ON OFF
1
Pin 31 / Pin 36 Reset Signal See table below.
2
3
Not used (Always ON)
4
5
6
7
Command Emulation See table below.
8
Reset Signal Switch 1 Switch 2
Pin 31 is enabled. ON ON
Pin 31/Pin 36 are enabled. ON OFF
Disabled OFF ON
Disabled OFF OFF
Command Emulation Switch 7 Switch 8
Star mode ON ON
ESC/POS (TM-295) ON OFF
ESC/POS (TM-290) OFF OFF
Not used (*1) OFF ON