Filter
Top Products
– 17 –
ENGLISH
6. Adjusting the Near-end Sensor
Use the following procedure to adjust the near-end sensor so it is compatible with
the size of roll paper you are using.
1 Open the printer cover.
2 Determine the diameter of the roll paper you are using and find the required
setting in the table below.
3 Insert the tip of a ballpoint pen or similar object into the hole of the adjuster,
and then push and side the adjuster to the desired setting.
When changing the setting, make sure that the position of the hole is aligned
with the alignment mark indicated by the arrow.
(Level 1) (Level 2)