Filter
Top Products
33
Samsung SCX-6320Toner/OPC
Cartridges
Samsung Cart. # SCX-6320D8 (Toner), SCX-
6320R2 (Drum)
OEM Stated Yield: 8,000, 18,000 respectively
Both of these cartridges use different items to reset
the printer. The toner cartridge uses a chip that must
be replaced/reset each cycle. There are different
manufacturers using this engine. Each manufacturer
has it’s own separate chip, even Samsung has
different versions. Make sure you have the correct
chip for the machine the cartridge will be going into.
Reset boxes are available to reset the OEM as well
as aftermarket chips. Some reset boxes will also
allow the change from one manufacturer to another.
Drum Cartridge: This cartridge uses a fuse to reset
the printer. The fuse is located on the gear side of the
cartridge. Starter cartridges do not have a fuse, but
the holder is there. The fuse must be replaced each
cycle. The fuse is a 250V 5 x 20mm 63mA fuse.
Make sure you have the correct fuse or printer
damage may occur!
Samsung SF-830 Toner Cartridges
Samsung Cart. # SCX-5312D6
OEM Stated Yield: 7,500
These cartridges do not use a chip or any type of
reset. They are included here because they use a
resistor to tell the machine what brand it is. Samsung
cartridges have a 30k Ohm resistor, where Xerox
cartridges have a 12k Ohm resistor. If you are
getting an “Invalid Cartridge” message, the wrong
resistor is installed. These resistors do not go bad,
and should never need to be replaced unless you are
changing brands. The resistors are under a small
contact plate on the gear side of the cartridge
Sharp AL-1000/Xerox XD-100 Toner
Cartridges
Sharp Cart. # AL-100TD, Xerox Cart. # 6R914
OEM Stated Yield: 6,000
The standard AL-100TD, and 6R914 cartridges are
not interchangeable. They have Oblong tabs on the
backside of the cartridges that are in different
locations. These tabs block the use of one brand in
the others machine. They can be made to be
interchangeable by cutting off the tabs, and sealing
up the hole. See our cartridge recycling instructions
for detailed information. These cartridges also do not
have any type of reset. There is a sensor inside the
cartridge that measures the mixture of toner to
developer. As long as there is enough toner for a
good mixture level, the toner lamp will stay off.
There are no page counters or “Killer Chips” for
these cartridges.
There are other versions of these cartridges however
that do have “Killer Chips”. The following are the
current Sharp AL-1000 Engine based cartridges that
also have the chips in them.
Sharp AR-150 Toner
Sharp Cartridge Part # AR-150TD
OEM Stated Yield: 6,000
These cartridges use the same supplies to recycle as
the AL-1000 (XD-100) cartridges. The difference is
that the oblong tab on the back side if the cartridge is
placed differently, and the cartridge has a “killer
chip” that shuts the machine down after 10,000