Summit HL-630 OPC Printer Accessories User Manual


 
38
OEM Stated Yield: 20,000 (All)
These cartridges do not use any reset procedures at
all. According to the Sharp manual, they should be
replaced when the copy quality deteriorates. No
codes will show on the display to change the
cartridge. NOTE: None of these cartridges are
interchangeable, they all are slightly different.
Sharp AL-800
Sharp Part # AL-80DR
OEM Stated Yield: 20,000
Open the front cover, and turn the power on. While
pressing and holding both the “Exposure mode” and
the “Clear key”, close the front cover. Continue to
hold these keys for 5 seconds, until the drum light
goes out.
Xerox XE60/80
Xerox Cartridge Part # 13R553
OEM Stated Yield: 18,000
With the power on, open the front door. Hold the
“Copy Contrast” button while closing the front door,
continue holding the button down for 3 seconds,
then release.
Sharp JX-9500 OPC/Toner
Sharp Cartridge Part # JX-95DR
OEM Stated Yield: 50,000 OPC, 25,000 Toner
There is a glass fuse located under a clip on the top
of the cartridge. Replace the fuse each cycle. The
fuse is a 250V, 80mA, 5x20mm fast acting glass
type. The toner waste bottle also uses a fuse- a
250V, 50Ma 5x20mm fast acting glass type.
Sharp JX-9600 Toner Cartridge
Sharp Cartridge Part # JX-96ND
OEM Stated Yield: 15,000
This cartridge needs to have the fuse replaced each
cycle. The replacement fuses are physically different
from the OEM but work the same. The fuses for this
cartridge are a special, very fast acting, type and
must be ordered from your supplier. The
replacement fuse must be inserted across the two
screws as shown. We have found it best to use solid
telephone wire and wire wrap around the fuse posts.
Soldering wires to the fuse can cause the
fuse to blow if too much heat is used.
Sharp JX-9600 OPC Cartridge
With the exception of starter cartridges, these
cartridges have a small board located on the end of
the cartridge. The small surface mount micro fuse
(125mA) must be replaced each cycle. If you have a
starter cartridge the machine must be reset through
the menu. (Starter cartridges do not have a fuse
board.) Almost all of the machines have a different,
and complicated reset procedure. Two of the most
popular machines are listed below. Other machines
probably also have a similar type of reset procedure,
but we have not been able to confirm them.
Sharp JX-9600
Sharp OPC Cartridge Part # JX96DR
OEM Stated Yield: 30,000
Turn the printer off.
With the MENU and ENTER keys depressed, turn
the power on.