Filter
Top Products
Chapter 2 Hardware Installation and Service 2-17
2.3 Service Procedures
2.3.1 Hot-Swapping the Netra CP3250 Blade Server
You can remove the Sun Netra CP3250 blade server without powering off the entire
chassis by performing these steps.
1. Power off the blade server.
See Section 2.3.2, “Powering Off the Netra CP3250 Blade Server” on page 2-17.
2. Remove the blade server.
See Section 2.3.3, “Removing the Netra CP3250 Blade Server” on page 2-18.
2.3.2 Powering Off the Netra CP3250 Blade Server
1. Shut down the operating system.
Log in and shut down any OS operating on the blade server or its companion
ARTM.
2. Deactivate the blade server.
Log in to the shelf manager and deactivate the blade server in the target slot.
For example, to shut down the blade server in slot 3, log in to the shelf manager
and type:
Wait for the blue Hot-Swap LED to light steadily before removing the blade
server.
# clia deactivate board 3