Filter
Top Products
27
CHAPTER
3
Configuring the Preinstalled Solaris
10 Operating System
This chapter walks you through the steps for configuring the Solaris 10 Operating
System (OS) that might be preinstalled on your Sun FireX2100 M2 server, depending
on your hard drive configuration. Solaris 10 6/06 is the earliest supported version.
Note – Unlike with SPARC
®
systems, you will not see the output of the preinstalled
Solaris 10 image through a monitor when you power on the server. The output of the
pre-installed image is directed to a serial console instead of a monitor that is attached
to the server.
Before You Begin
Before you begin configuring the preinstalled OS, be sure to do the following:
1. Perform initial configuration of the service processor and determine the server’s
network settings, as described in Chapter 2.
2. Gather the information that you will need for the configuration, as listed in the
“Installation Worksheet” on page 27.
Installation Worksheet
Use the worksheet in TABLE 1 to gather the information that you need to configure
the pre-installed Solaris 10 OS. You only need to collect the information that applies
to your application of the system.