Filter
Top Products
1-3
Chapter 1: Introduction
Note: You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
Onboard Controllers/Ports
The color-coded I/O ports include two COM ports (one header and one port), a VGA
(monitor) port, Seven USB 2.0 ports (2x rear, 4x header, 1x type A), PS/2 mouse
and keyboard ports, two gigabit Ethernet ports and one dedicated IPMI LAN port.
Graphics Controller
The H8DGU-F features an integrated Matrox G200eW graphics chip, which includes
16 MB of DDR2 memory.
Other Features
Other onboard features that promote system health include onboard voltage moni-
tors, auto-switching voltage regulators, chassis and CPU overheat sensors, virus
protection and BIOS rescue.
1-3 Server Chassis Features
The 1022G-URF is built upon the SC815TQ-R700UB chassis. Details on the chassis
and on servicing procedures can be found in Chapter 6.The following is a general
outline of the main features of both chassis.
System Power
The SC815TQ-R700UB features a redundant 700W power supply consisting of
two power modules. The system does not need to be shut down when replacing or
removing a single power supply module.
SATA Subsystem
The SC815TQ-563UBP chassis was designed to support four hot-swap SAS/
SATA hard drives.
Note: A SAS or SATA UIO card must be installed to support SAS or SATA drives.