Filter
Top Products
6-6
SUPERSERVER 5016T-TB User's Manual
SATA Power Cables
SATA power cables should be routed so that they do not block the airfl ow through
the chassis. See the serverboard layout diagram for the location of the cable con-
nections.
DVD-ROM Drive Installation
The top cover of the chassis must be opened to gain full access to the DVD-ROM
drive bay. The DVD-ROM drive must have a "slim" profi le to fi t into the 5016T-TB.
Installing a DVD-ROM Drive
Turn off the power to the system and remove the AC power cord.1.
Release the retention screws that secure the unit to the rack.2.
Grasp the two handles on either side and pull the unit straight out until it 3.
locks (you will hear a "click").
Depress the two buttons on the top of the chassis to release the top cover 4.
and at the same time, push the cover away from you until it stops.
Lift the top cover from the chassis to gain full access to the inside of the 5.
server.
Disconnect the power and data cables from the drive to other chassis compo-6.
nents including the motherboard and backplane.
Remove the old drive by depressing the release tab, then pulling the drive out 7.
of the chassis.
Insert the new drive unit in the slot until the tab locks into place.8.
Connect the data and power cables to the backplane and motherboard.9.
Replace the chassis cover, reconnect the AC power cord and power up the 10.
system.