Filter
Top Products
Chapter 5: Advanced Serverboard Setup
5-5
5-4 Connecting Cables
Now that the processors are installed, the next step is to connect the cables to
the serverboard. These include the data (ribbon) cables for the peripherals and
control panel and the power cables.
Connecting Data Cables
The ribbon cables used to transfer data from the peripheral devices have been
carefully routed in preconfi gured systems to prevent them from blocking the fl ow
of cooling air that moves through the system from front to back. If you need to
disconnect any of these cables, you should take care to reroute them as they
were originally after reconnecting them (make sure the red wires connect to the
pin 1 locations). If you are confi guring the system, keep the airfl ow in mind when
routing the cables. The following data cables (with their serverboard connector
locations noted) should be connected. See the serverboard layout diagram in this
chapter for connector locations.
CD-ROM cable (JIDE1)
Floppy Drive cable (JFDD1)
SCSI cables (JA1, JB1)
Control Panel cable (JF1, see next page)
Connecting Power Cables
The H8DSR-8 has a 20-pin primary power supply connector "J1B4" for connec-
tion to the ATX power supply. Connect the appropriate connector from the power
supply to J1B4 connector to supply power to the serverboard. See the Connector
Defi nitions section in this chapter for power connector pin defi nitions.
In addition, your power supply must be connected to the 8-pin Processor Power
connection at JPW2. For systems with heavy loads, an additional 4-pin power
connection has been included at J32.