Filter
Top Products
31
iPort/AFM
Quick Start
Follow these steps to start sending and receiving I
2
C messages:
1. Install iPort/AFM as directed in the “Installation Instructions” section of this
User’s Guide.
2. Use a terminal emulator program (like the Windows Terminal Program or
Windows Hyperterminal) to get started. Remember to select the correct
Com Port (COM1, COM2,…) and set the terminal emulator to 19200 Baud, 8
Data Bits, No Parity, and 1 Stop Bit.
3. Enter
//
to get an iPort/AFM Status Report.
Note
: All iPort/AFM commands
are terminated with a Carriage Return character. On most terminal emulators
press the Enter key.
4. Enter
/E1
to Enable the Echo/Prompt feature. This makes it easier for a
person to interact with the iPort/AFM from a terminal.
5. Enter
/F0
or
/F1
to set iPort/AFM’s communications Flow Control to match
your terminal.
6. Enter
/Ixx
(xx = 02…FE even) to set iPort/AFM’s Own I
2
C Slave Address.
7. Enter
/O
to Open the iPort/AFM Connection. The iPort/AFM does not need to
be connected to an I
2
C Bus to open a connection.
8. Enter
/Dxx
(xx = 00…FE even) to select a Destination I
2
C Slave Address.
9. Enter
/Ttext
(text = ASCII or Hex-Equivalent ~00…~FF) to Master Transmit a
message to the current Destination I
2
C Slave device.
10. Enter
/Rn
(n = 0…32767) to Master Read a message from the current
Destination I
2
C Slave device.
Syntax: [CR] = Carriage Return
The following sections provide detailed information on all
iPort/AFM
ASCII
Commands and Prompts.
For the latest product information and application note
visit our web site at:
http://www.mcc-us.com