Filter
Top Products
Chapter 4: BIOS
4-11
If a drive fails after the installation of a new software , you might want to
change this setting and try again. Different OS requires different Bus Master
clock rate.
Large Disk Access Mode
This setting determines how large hard drives are to be accessed. The
options are DOS or Other (for Unix, Novellle NetWare and other operating
systems).
Advanced Chipset Control
Access the submenu to make changes to the following settings.
Force Compliance Mode
This feature allows you to enable the PCI-Express Compliance Mode. The
options are: Disabled or Enabled.
Memory RAS Feature Control
Select this option in order to enable the special feature of DIMM sapring
or memory mirroring. The options are Mirroring, Sparing and Standard.
Clock Spectrum Feature
If "Enabled", BIOS will monitor the level of Electromagnetic Interference
caused by the components and will attempt to decrease the interference
whenever needed. The options are Enabled and Disabled.
Memory Remap Function Control
PCI memory resources will overlap with the physical memory if 4GB of
memory or above is installed on the motherboard. When this occurs, enable
this function to reallocate the overlapped physical memory to a location
above 4GB to resolve the memory overlapping situation.
DRAM Data Integrity Mode
If enabled, this feature allows the data stored in the DRMA memory to
be integrated for faster data processing. The options are 72-bit ECC,
144-bit ECC, Auto and Disabled.
ECC Error Type
This setting lets you select which type of interrupt to be activated as a
result of an ECC error. The options are None, NMI (Non-Maskable
Interrupt), SMI (System Management Interrupt) and SCI (System Control
Interrupt.)