Filter
Top Products
SecurityExpressions Server User Guide
48
Active Directory (Active Directory Connection Monitor only)
Set the Active Directory (event log) monitoring options.
IncludeAllDomainControllers
Retrieves names of all Domain Controllers on the Domain system where the monitor resides and
monitors the event logs of all Domain Controllers. One (1) is the default setting. If
IncludeAllDomainControllers=0 you must add the Include key and identify the device to monitor.
Exclude
Comma-separated list of device names to omit from monitoring.
Include
Comma-separated list of device names to monitor.
Processing the Configuration File
When the Connection Monitor recognizes a new device on the network, it compares the device IP
address to the IP ranges defined in the configuration file, excluding the Default settings, starting
with the first range in the file and proceeding in order. If the address falls in one of the IP
ranges, that group's audit server list and distribution method determine where to connect.
If the IP address does not fall within any of the specified ranges, a group whose
IPRange=Default accesses the audit server list and distribution method.
You do not have to specify a Default IP range. However, if a Default range does not exist and the
IP address does not correspond to any of the defined ranges, the monitor does not contact the
audit server and the device remains unaudited.
Configuration File Syntax
To specify configuration data, you manually edit the dmconfig.txt file and include the required
information about the IP ranges. After editing the configuration file, you must stop and restart
the service through the Service Management Console, which is accessible through Administrative
Tools.
Tip: If you are using more than one connection monitor on the same computer, use the same
configuration file to configure them.
Be aware that if you're using the DHCP Plug-In Connection Monitor, it's Microsoft's DHCP
Server Service that you have to stop. Since this service controls other functions on the
network, stopping it might have other temporary effects on the network.
Tip: Use the # character at the beginning of all comment lines to ensure they get ignored when
the file processes.
The configuration file syntax is similar to .ini file syntax, such as:
[IP_RANGE_1]
IPRange=10.0.3.0:254
AuditServers=server1,server2