Filter
Top Products
DS 6608 Product Reference Guide1-4
Setting Up the Digital Scanner
Installing the Interface Cable
1. Plug the interface cable modular connector into the cable interface port on the bottom of the scanner handle. (See Figure 1-
2.)
2. Gently tug the cable to ensure the connector is properly secured.
3. Connect the other end of the interface cable to the host (see the specific host chapter for information on host connections).
Figure 1-2. Installing the Cable
Different cables are required for different hosts. The connectors illustrated in each host chapter are
examples only. Connectors vary from those illustrated, but the steps to connect the digital scanner remain
the same.
Removing the Interface Cable
1. Using the tip of a screwdriver, depress the cable’s modular connector clip.
Figure 1-3. Removing the Cable
2. Carefully slide out the cable.
3. Follow the steps for Installing the Interface Cable on page 1-4 to connect a new cable.
Clip
To host
Cable interface port
Interface cable modular connector
Note