Filter
Top Products
4-1
Chapter 4
Parameter Menus
Introduction
The LS 2106 is shipped with the settings shown in the Default Parameters beginning on page
4-2. These default values are stored in non-volatile memory and are preserved even when the
scanner is powered down. You can change these default values by scanning the appropriate
bar codes included in this manual. These new values replace the standard default values in
memory. The default parameter values can be recalled by scanning the SET ALL DEFAULTS
bar code on page 4-7.
The scanner automatically identifies the host type on power-up. It makes this determination
provided the host is powered-up before the scanner is attached to it. The following table lists
the defaults for all parameters. If you wish to change any option, scan the appropriate bar
code(s).