Filter
Top Products
2-7
Set Up
3. An output cable from the battery box connects the LS 4004i to the RS-232C input
device. Connect one end of this cable to the battery box and the other end to the
appropriate port on the host device (Figure 2-6).
Figure 2-6. RS-232C Battery Operation
Note:
Coil cables that terminate in a 25-pin D-type connector have a power
receptacle on the side of the connector assembly.
Keyboard Wedge
To setup the keyboard wedge configuration:
1. Connect the keyboard connector on the Synapse cable to the host keyboard.
2. Connect the host connector on the Synapse cable to the keyboard interface port on
the host.
3. Connect the Synapse scanner connector to the scanner.
Portable
Terminal
Power
Supply
(Optional)
LS 4004i
Battery Box
Output Cable